Blushmere Signature Styling Guide

Blushmere Signature Kit - Design 1 Instructions

Follow these step-by-step instructions to complete your Blushmere Signature Design 1.

1, Place the two fern stems into the grapevine wreath. We want to create fullness on the left side of the wreath. 

 

2. Place  the grass bush stems into the fern, one in the top and one into the bottom half. 

 

3. Place the mum stems, baby's breath and carnations throughout the greenery as you see fit. 

4. Place the bow on the top right where we placed the fern stems in the wreath. 

5. The last step you will go through all stems and floral to fluff and balance it out. You will also arrange the bow loops Cut the end of ribbon at an angle or what's aesthetically pleasing to you. 

 

Blushmere Signature Kit - Design 2 Instructions

Follow these step-by-step instructions to complete your Blushmere Signature Design 2.

 

1. We are going to place the fern stems in the top of wreath so they are Cascading down the sides of the wreath, make sure they over lap a bit at the top but not too much so you leave space for the florals. 

 

2. Next will be the grass bush stems, you will place these opposite of each other. You can do one on top left and one on bottom right side of wreath. 

3. We are going to place the carnations and cut off 3 of the mum's from the full stem and place in the top center of the wreath. 

4. Next we will place the rest of florals throughout the wreath. 

5. You will place the bow at the bottom center of the wreath. 

 

6. Go through the wreath fluff everything up, fluff your bow, create balance and hang on your wall. Be proud of the product you completed.